Warning
Keep the machine away from potential sources of interference.
Do not expose the machine to direct sunlight, heat, dust or excessive humidity (use only in a clean food service environment).
Warning
RISK OF ELECTROCUTION
The power plug is the device used for disconnection in case of problems or emergency and it must be easily accessible at all times.
Only use the power cord provided with the machine.
Never use a machine which is damaged or has a defective power cord. With signs of damage, for example if there is a smell of burning or visible insulation damage, unplug the machine, immediately stop using it and contact your local service organisation.
The power cord must only be repaired by a service organisation appointed by the manufacturer.
Make sure that the cable is not near a hot surface.
Be careful to ensure that the power cord is not trapped and does not rub against sharp edges.
Repair, commissioning and service operations must only be performed by a service organisation appointed by the manufacturer.
Never open the machine, nor remove any parts except for the instructions specified in manuals (e.g. User Manual).
Only connect the machine to the electrical power sources specified and a power supply network provided with a protective earth.
Requirement for Australian deviation: disconnection incorporated in the fixed wiring is in accordance with AS/NZS 3000.
Warning
The refrigerant is a flammable gas. Do not store explosive substances, such as aerosols, inside and around the machine.
Make sure that the ventilation openings are free and clean.
Never use a machine which is damaged or has a leak from pipes. With signs of leak, unplug the machine, immediately stop using it and contact your local service organisation. Avoid any naked flames around the machine and move anything flammable away from the machine.
Repair, commissioning and service operations must only be performed by a service organisation appointed by the manufacturer.
Warning
The hot water, steam, milk and coffee dispensed are hot. Avoid direct contact with the skin.
Always place a suitable cup under the outlet before dispensing products.
During automatic cleaning, hot cleaning solution and steam are released several times.
Warning
HOT SURFACE
The cup warmer panel could reach 90 °C, contact may cause burns in less than a second.
Warning
Everclean and Eversys cleaning ball should be considered potentially dangerous. When performing any operation on the machine, local safety regulations must be followed. It is imperative to wear protective gloves and glasses when working with potentially dangerous materials.
For any other materials referred to in manuals (e.g. Everclean and Eversys cleaning balls) corresponding Material Safety Data Sheets (MSDS) should be consulted before the first use, adequate protective measures should be applied and any applicable regulations should be followed.
Warning
It is imperative to use only the products, accessories, spare parts and software specified in manuals (e.g. User Manual).
Warning
Except for cups, do not place anything on top or above the machine.
The machine is not suitable for installation in an area where a water jet or water spray might be used.
The machine must not be located on a surface that is sprayed or cleaned with a water hose, steam jets, steam cleaner, or similar equipment.
The machine must be placed and levelled on a horizontal, water-resistant, heatproof, and sturdy base capable of bearing its weight, see technical data in the Commissioning section.
For operating, service and safety reasons the machine should be installed with a clearance of not less than 50 mm at the back and sides from the building or non-approved equipment. A minimum working space of 650 mm in front the coffee machine and overhead clearance of at least 250 mm above the bean hoppers are recommended. A clear height of 1000 mm for E'line, Enigma, Shotmaster and accessories, 950 mm for Cameo machines and accessories (with high feet) and 900 mm for Légacy, Cameo machines and accessories (with standard feet) from the top of the installation surface should be ensured. The height of the installation surface above the floor is at least 800 mm. If the coffee machine connections are to be run downwards through the counter, please make space for the lines, which can reduce the usable space below the coffee machine.
The machine is only to be installed in locations where its use and maintenance is restricted to trained personnel. Please refer to "Persons".
Only connect the machine to the mains in accordance with the information on the rating plate, see Rating plates of machines.
Adjustment of the frequency is automatic. No action is required.
The power cord must be in accordance with local regulations.
Voltage/current specifications are as listed in the table Electrical data and power overview of machines.
Note
To connect the machine to the water mains, use only the original supplied hoses.
Any necessary on-site preparatory work for electricity, water and drainage connections at the customer‘s premises is to be arranged by the machine owner / manager. The work must be carried out by authorised installation technicians in compliance with general, country-specific and local regulations. Eversys service organisations may only connect the machine to existing prepared connection points. Eversys appointed service organisations are neither authorised, nor responsible for carrying out any on-site installation work prior to connection.
Click to get access to the checklist of requirement prior to initial commissioning.
Warning
Always switch off the machine at the main switch before undertaking cleaning tasks. Use only a damp cloth and protect the machine against permanent water projections.
Regular cleaning is mandatory in order to ensure problem-free operation of the machine and to ensure optimum coffee quality. Refer to method and frequency under Care and Cleaning.
Only use original Eversys cleaning products. Use of products that are not explicitly recommended by Eversys could damage the machine or void warranty.
It is forbidden to clean the machine with a water jet or a water spray.
Make sure to have your machine maintained at regular intervals to ensure safe and efficient performance. Refer to Maintenance.
Risk of spoiled food residue: if the machine is not cleaned regularly, milk and coffee residue may accumulate in the machine, clog the outlets or get into drinks. Clean the machine and add-ons according to Cleaning plans and Overview of cleaning on machines.
Warning
People, including children, who, because of their physical, sensory or cognitive abilities, or due to their inexperience or lack of knowledge, are not able to use this machine safely, are not allowed to operate it unless under the supervision or on the order of a responsible person.
The machine is not suitable for children under the age of 8 years. Children above the age of 8 or persons who are challenged with respect to physical, sensory or mental abilities must never approach the machine alone and must always be supervised.
Children are not allowed to play with the machine.
Children are not permitted to perform any cleaning on the machine.